Running StickOS BASIC on a chipKIT board

Have you ever wished you could examine and manipulate the pins and peripherals of your MCU *interactively*, while it was live and connected to your embedded circuit, rather than using just “reset and run” debugging? If so, StickOS BASIC may be for you! With StickOS BASIC, you can log in to your MCU using nothing but a terminal emulator, and then take full control of the MCU from a command-line, just as if you had an In-Circuit Emulator. StickOS can run either in “slave” mode, tethered to and controlled by a host computer as a glorified intelligent I/O port, or it can run in “master” mode, programmed in BASIC, interactively debugged, and even configured to autorun its BASIC program autonomously. In StickOS BASIC, it is trivial to examine and manipulate I/O pins. I/O pins can be configured for digital input or output, analog input or output, servo output, or frequency output. Once a pin is configured, it can be bound to a BASIC variable, and from then on, examining or manipulating the pin is as simple as examining or manipulating the bound variable. For example, to configure pin 3 for servo output, bind it to the variable “motor1”, and then set it up for a 1ms (1000us) PWM pulse width is as easy as (interactively, at the command-line, or in a program):
    > dim motor1 as pin 3 for servo output
    > let motor1=1000
    > _
In StickOS BASIC, it is equally trivial to use timers, UARTs, advanced I2C or SPI peripherals, as well as HD44780-compatible LCDs and simple scanned keypads. And most importantly, it can all be done interactively — no more guessing what your MCU is up to! The StickOS debugger supports command-line program interruption, breakpoints, assertions, watchpoints, live variable (and pin) manipulation and examination, execution tracing and single-stepping, sampling profiling, and even edit-and-continue! When you’re ready to move up, you can then port your BASIC program to C using the MPLAB X StickOS Skeleton project, and take advantage of all the same pin/peripheral configuration, flash manipulation, etc., used by StickOS BASIC. A detailed introduction to StickOS on the chipKIT boards is here: An overview of the StickOS BASIC language features is in the Quick Reference guide, here: More information and downloads for the chipKIT boards are available here:
VN:F [1.9.22_1171]
Rating: 0.0/10 (0 votes cast)
VN:F [1.9.22_1171]
Rating: 0 (from 0 votes)