No target found chipKIT Uno32 on Arduino 1.8.5 and chipKIT-core 1.4.3

Post Reply
hadiknown
Posts: 1
Joined: Wed Nov 08, 2017 12:47 am

No target found chipKIT Uno32 on Arduino 1.8.5 and chipKIT-core 1.4.3

Post by hadiknown » Wed Nov 08, 2017 12:52 am

I'm just starting out with the Uno32 board and I'm having a world of trouble. I wrote a simple bit of code to have two LEDs alternate in flashing and that compiles fine:

Code: Select all

void setup() {
 pinMode(13, OUTPUT);
 pinMode(43, OUTPUT);
}

void loop() {
 digitalWrite(13, HIGH);
 digitalWrite(43, LOW);
 delay(500);
 digitalWrite(13, LOW);
 digitalWrite(43, HIGH);
 delay(500);
}
However, I get this error when I try to upload to the board:

Arduino: 1.8.5 (Mac OS X), Board: "chipKIT UNO32"

Sketch uses 6736 bytes (5%) of program storage space. Maximum is 126976 bytes.
Global variables use 3060 bytes (18%) of dynamic memory, leaving 13324 bytes for local variables. Maximum is 16384 bytes.
Programmer for Microchip PIC32 microcontrollers, Version 2.1.24
Copyright: (C) 2011-2015 Serge Vakulenko

No target found.
An error occurred while uploading the sketch

This happened on my Windows machine too. I read issues from years ago about pic32prog, but they claimed that the issue should've been fixed already. Please let me know if more information is required. I hope someone can help.

EmbeddedMan
Posts: 597
Joined: Tue May 24, 2011 9:24 pm
Location: Minneapolis, MN
Contact:

Re: No target found chipKIT Uno32 on Arduino 1.8.5 and chipKIT-core 1.4.3

Post by EmbeddedMan » Wed Nov 08, 2017 1:27 am

hadiknown,

OK, we'll do our best to help you out.

1) What version of chipKIT-core do you have installed in the IDE?

2) Can you see the serial port that the FTDI chip on the UNO32 creates? I.e. if you do "ls /etc/dev" before you plug in the UNO32 and then after, do you see a new TTY port? (I'm not a Mac guy, so I'm a little bit guessing here, but you get the idea.)

*Brian

User avatar
majenko
Site Admin
Posts: 2164
Joined: Wed Nov 09, 2011 7:51 pm
Location: UK
Contact:

Re: No target found chipKIT Uno32 on Arduino 1.8.5 and chipKIT-core 1.4.3

Post by majenko » Wed Nov 08, 2017 10:46 am

It does sound like you have the wrong (or no) port selected...

By the way, the path is /dev not /etc/dev ;)
Why not visit my shop? http://majenko.co.uk/catalog
Universal IDE: http://uecide.org
"I was trying to find out if it was possible to only eat one Jaffa Cake. I had to abandon the experiment because I ran out of Jaffa Cakes".

Post Reply