Last year I bought one of these units with
the intention of using it to develop PIC32 support
in my PICMicro programmer found at
Well, it's been a bit longer than anticipated but
I finally got around to it.
Here is an overview of the configuration.
I used my tool to update the firmware to the latest
If you do update the firmware then please understand
I can't be responsible if anything goes wrong and you
will need to reboot the R-PI (currently at least) to
return the UART feature to the GPIO pins to talk to
Later I will see about making some project templates
to bypass using the IDE.
It's all a bit quiet in the chipKITPi forum isn't it?
1 post • Page 1 of 1