Page 1 of 1

Issue Programming UC32 in MPLAB Using Bootloader

Posted: Thu Sep 08, 2016 10:36 pm
by RMichael910
Good afternoon,

I want to program a UC32 using MPLAB, without overwriting the bootloader. This forum post was very helpful for getting everything set up:


I was able to program my UC32 in MPLAB by using AVRDUDE, by following the suggestions in that post. However, I am not able to get any programs to actually execute on the board. I started with a simple program that flashes LEDs 4 and 5 (RG6 and RF0) on the board, but nothing happens.

I am wondering if anyone else has had luck programming a Chipkit in this manner, and if so, could you provide any tips / example code?