why can't i use uart port1 "problem solved"

Post Reply
Seniorlemuren
Posts: 6
Joined: Sat Feb 21, 2015 10:41 am

why can't i use uart port1 "problem solved"

Post by Seniorlemuren » Sun May 10, 2015 11:29 am

I am trying to open a serial communication sending data from Arduino mega to Uno32 port1 (pin 0,1). No data is transferred. I have disconnect the USB from the board and support it from power supply. I can not se the LED on Uno32 blinking. If I use port2 (pin 39,40) on Uno32 the LED is blinking in the same time as the LED on mega is blinking and data is transfered.

Edit: Forget this question. It was bad connection.

Post Reply