Repeated start condition, i2c

Post Reply
andy89
Posts: 1
Joined: Sat May 18, 2013 2:12 pm

Repeated start condition, i2c

Post by andy89 » Sat May 18, 2013 2:22 pm

Hi,
i just bought a chipkit max32.
I was working on a university project with biometric sensor.
I was using an Arduino and MBED but I realized that they both had too less ram, so I was stucked with the project.
So i bought the max32, because 128K of ram were sufficient.

But now i have a board with VERY OLD libraries (compared to Arduino or MBED), and i can't nomore interact with the sensor due to the lack of the Repeated start condition of the i2c.

How can i do?
Someone developed these new libraries??

Post Reply