Network Shield - CAN bus

Post Reply
eldoori
Posts: 6
Joined: Thu Jul 21, 2016 2:24 pm

Network Shield - CAN bus

Post by eldoori » Mon Sep 12, 2016 12:53 pm

Hi all,

I have a MAX32/Network Shield combo and I've been trying to get everything working accordingly. So far I've managed to send data from the MAX32 to my computer and reveive the data. However, when I send data from my computer to the MAX32 it does not even triggure the interrupt.

After some digging I found that my problem is simular to this post: http://www.chipkit.net/forum/viewtopic.php?f=18&t=3122

The solution posted in that thread is to configure the filter to accept all messages, this does not solve my problem though. I use the Peak can2usb cable and the PCAN-VIEW software to send and receive messages from my computer. As for the software I use the candemo.pde that came with the libraries installed from the digilent website.

If someone else had the same issue it would be of huge help if you would tell me how you solved the issue.

Thanks in advance!

User avatar
Jacob Christ
Posts: 723
Joined: Sat May 28, 2011 6:34 am
Location: Southern California
Contact:

Re: Network Shield - CAN bus

Post by Jacob Christ » Mon Oct 24, 2016 1:42 pm

One of my colleges has done a little bit with the CAN, it was a while ago and I don't know if can help, but I will point him to this post. If you don't hear from him, he probably has nothing.

Jacob
PONTECH Quick240 an industrial form factor platform for chipKIT and Arduino users.

Post Reply