QuickIO Shield

Post Reply
User avatar
majenko
Site Admin
Posts: 2164
Joined: Wed Nov 09, 2011 7:51 pm
Location: UK
Contact:

QuickIO Shield

Post by majenko » Fri May 13, 2016 4:43 pm

Ever wanted to just slap a couple of buttons, knobs and/or LEDs on to a chipKIT board to quickly try something out?

Ever thought "I could really use a potentiometer on an analog input right now to set this parameter in my sketch..."?

Well life just got a whole lot easier for you.

Introducing the new chipKIT QuickIO shield.
2016-05-13 14.48.20-sm.jpg
2016-05-13 14.48.20-sm.jpg (178.72 KiB) Viewed 327 times
Four buttons, two potentiometers and eight LEDs mean you instantly have at your fingertips just those controls you want.

Achieve in a matter of seconds what rapidly becomes a chore using breadboard and wires.

Available now from my eBay Shop!

http://stores.ebay.co.uk/Majenko-Technologies

Note: this shield uses the "R3" footprint and requires the IOREF pin. This makes it also work flawlessly on Arduino boards as well. If your board lacks the IOREF pin just solder in a wire between IOREF and +3.3V (or +5V for 5V Arduino boards).
Why not visit my shop? http://majenko.co.uk/catalog
Universal IDE: http://uecide.org
"I was trying to find out if it was possible to only eat one Jaffa Cake. I had to abandon the experiment because I ran out of Jaffa Cakes".

Post Reply