[solved] ChipKit Lenny - Can we remap pin for a test?

Post Reply
sopal
Posts: 4
Joined: Fri Dec 15, 2017 9:12 pm

[solved] ChipKit Lenny - Can we remap pin for a test?

Post by sopal » Wed Dec 20, 2017 4:15 pm

solved:
after read this docu
have checked out this for my topic question:

Code: Select all

// remap U1TX to RC7
	if (mapPps(6,PPS_OUT_U1TX))...
txs

-----------------------------------------------------



hi everybody,

i am new user and say to everybody "hi" :)
hope for a help in my asking. sry for the bad english.

i bought last days the ChipKit Lenny board. still waiting for delivery for first test.
in the meantime i read here and there and found for me a question for possibles in my later doings.
i would test an fixed adapter on the board pinheader and would use
for UART1 (Serial1 ) other pins, means U2Tx (2) i would use RC7 (6)
( i am little confus about UART1 and U2TX/U2RX naming )

i saw the UARTn pins for the board
U2Tx ( RB7 ) Board Pin 2
U2Rx ( RC6 ) Board Pin 4

i read in the docu of the Lenny board

side 9 B.3 UART

Serial0 / Uart2
RX (RC8) 0
TX (RC9) 1

Serial1 / Uart1
Rx (RC6) 4
Tx (RB7) 2

side 7 A Pin Mapping
2 RB7 INT0/U2TX
4 RC6 INT2/U2RX


my ask is:

what is mean with U2TX, is this the pin name of the chip or intern name?

cause i would remap this one pin simple by
RPC7R = B0001; // U1TX

but it looks like the PPS ( only U1TX is in the table for RPB7 and RPC7 )
is not possible to this U2TX but it is in the same output pin selection table.

i would start the aduino code by
RPC7R = B0001;

and would start

Serialn.beginn(115200);

have i then this UARTn on Board Pins
6 (RC7) as TxD
4 (RC6) as RxD

is this the correct way?
do i can edit for a test the Board_Data file
or full other way?

for your help and answere
thank you
regards
sopal

Post Reply